DHC-2 Dehavilland Beaver Overhauls

We do have a harness board to fabricate DHC-2 Beaver wire harnesses. However in over a decade of experience what we have found is that no beaver is the same. There are always slight differences. Before building any harness we want to see pictures and have an in depth discussion about your project. This way we can understand your goals, what you expect and meet your needs.

No, this is impossible. We have been involved in so many DHC-2 beaver overhauls and this is not possible, no matter what some may say. Not to say that wiring a DHC-2 beaver takes a long time, it just takes longer than 2 days to make sure everything is done properly and in accordance with applicable safety and industry standards.

It really depends on what we need to provide. Some companies will quote you $10,000. This is a dead giveaway that it will cost you way more, probably 50% more. We analyze the project, will give you REALISTIC numbers, not something low to just get the job and then bill you lots of money after. We keep it real and reasonable. We are always open to discuss options, budgets and what would you like to have installed. Some want a full glass cockpit with autopilot and others want a working airplane with basic systems.

Yes, we stamp and terminate everything in our state of the art shop.